ESP8266 Send DHT Temperature & Humidity Readings to MQTT & OLED Display I had an extra ESP8266 laying around (as we all should) and decided to create a Temperature & Humidity Sensor for my office. The Raspberry Pi I was previously using for this has since been repurposed into a tracked robot tasked with such […]
ESP8266 Send DHT Temperature & Humidity to MQTT & OLED Display Read More »
IoT Temperature & Humidity to Initial State Using a Raspberry Pi & DHT22 I have a Raspberry Pi 3 running OpenHab located on my desk next to my iMac. Since I spend most of day here, I thought it would be good to get some Temperature & Humidity data reading. Right now I am sending
IoT Temperature & Humidity to Initial State Using a Raspberry Pi & DHT22 Read More »
ESP8266 NodeMCU Relay WiFi Garage Door Opener with Blynk //July 21 2016 Cleaned Up and Updated Code – Added IP Address Display and WiFi Strength to Blynk App Recently, I purchased a Chamberlain MYQ Internet Gateway for my primary Garage Door. This only took about 20 minutes to get setup and now I had remote
ESP8266 NodeMCU Relay WiFi Garage Door Opener with Blynk Read More »