Popular Categories
DFRobot Devastator Tank Robot Part 2 Raspberry Pi Python Code
DFRobot Devastator Tank Robot Part 2 Raspberry Pi Python Code In Part 1 of this build, we covered parts and assembly of the DFRobot Devastator Tank Robot. Now we’ll go over some of the Python Code we’re running on the Raspberry Pi with the RaspiRobot Motor Driver Board. You could definitely do this with […]
ESP8266 NodeMCU WiFi IoT Garage Door Opener Relay with Cayenne
ESP8266 NodeMCU WiFi IoT Garage Door Opener Relay with Cayenne Wait! Didn’t you already do a post on an ESP8266 NodeMCU Garage Door Opener? Yup, I did! But for that post here we used the online IoT service/app Blynk. This new post makes some additions and also explores a new online IoT service called Cayenne. As […]
DFRobot Devastator Tank Treaded Tracked Robot Part 1 Assembly
DFRobot Devastator Tank Treaded Tracked Robot Part 1 Assembly You may have seen a few pictures of Rex our bearded dragon on top of a Tank Treaded Robot in some of my other posts. In this post I will go though the initial assembly and build of the DFRobot Devastator Tank Treaded Tracked Robot (although […]
Spooky Halloween ? Creepy Eyes ? Arduino & RGB LED Strip
With Halloween only a few weeks away, I just had to get started on some related Maker projects! I recently purchased an Adafruit Metro (which is similar to an Arduino Metro) for the purposes of reloading the bootloader onto a corrupt Nano(for another project). *Disclaimer: Most if not all links on this page will be Affiliate […]
ESP8266 Send DHT Temperature & Humidity to MQTT & OLED Display
ESP8266 Send DHT Temperature & Humidity Readings to MQTT & OLED Display I had an extra ESP8266 laying around (as we all should) and decided to create a Temperature & Humidity Sensor for my office. The Raspberry Pi I was previously using for this has since been repurposed into a tracked robot tasked with such […]
IoT Temperature & Humidity to Initial State Using a Raspberry Pi & DHT22
IoT Temperature & Humidity to Initial State Using a Raspberry Pi & DHT22 I have a Raspberry Pi 3 running OpenHab located on my desk next to my iMac. Since I spend most of day here, I thought it would be good to get some Temperature & Humidity data reading. Right now I am sending […]
ESP8266 NodeMCU Relay WiFi Garage Door Opener with Blynk
ESP8266 NodeMCU Relay WiFi Garage Door Opener with Blynk //July 21 2016 Cleaned Up and Updated Code – Added IP Address Display and WiFi Strength to Blynk App Recently, I purchased a Chamberlain MYQ Internet Gateway for my primary Garage Door. This only took about 20 minutes to get setup and now I had remote […]
- « Previous
- 1
- 2
- 3
- 4